14 Total Knee Arthroplasty
with Left and Right Leg Spars Standard Component Installation
and Adjustment Standard Component Installation and Adjustment Prior to procedure set up, refer to the Standard Component Installation and Adjustment section and complete the required steps. VIEW NOW CONTINUE WITH SETUP 1 Radiolucent Leg Spars Attach both the left and right Hana Radiolucent Leg Spars to the table and lock in place. Radiolucent Leg Spars Attach both the left and right Hana Radiolucent Leg Spars to the table and lock in place. View Part 2 Pelvic Pad Place the Pelvic Pad on the table. If extra support is desired, slide the Lateral Board Assembly (without Lateral Perineal Post) on the table instead. 3 Patient Safety Strap Slide the Patient Safety Strap into place. Adjust the table to the appropriate height for patient transfer from the stretcher. 4 Traction Boot Put the appropriate size Traction Boot (small, large, or optional extra-large) on the patient’s non-operative foot while the patient is on the stretcher. Patient Instructions Patient Instructions Transfer the patient to the table in the supine position and secure with Patient Safety Strap. 5 Perineal Post Insert the padded Perineal Post into the table. Move the patient to establish firm contact with the Perineal Post and adjust the Patient Safety Strap as appropriate. 6 Traction Boot Attach the Traction Boot on the non-operative leg to the Traction Mount on the non-operative Leg Spar. 7 Arm Boards Install an Arm Board with pad to both left and right sides of the table and position the patient’s arms out to the side. Secure the patient’s arms. 8 Knee Flexion System Drape the operative side Hana Radiolucent Leg Spar and attach the sterilized Knee Flexion System to the Leg Spar. Patient Instructions Patient Instructions Place the operative foot on the Foot Plate of the Knee Flexion System and secure according to surgeon protocol. Setup Complete The Total Knee Arthroplasty with Left and Right Leg Spars
setup is now complete. For more information or questions about this setup or any setup, please refer to the Owner's Manual or contact Mizuho OSI for additional support.