2 Orthopedic Traction Arc
Installation Orthopedic Traction Arc
Installation With the Traction Arc in its stowed position on the cart, lower the table to its lowest height and roll the cart up to the Foot-End of the Base. The cart wheel extensions should straddle the Foot-End base. Standard Component Installation and Adjustment Prior to procedure set up, refer to the Standard Component Installation and Adjustment section and complete the required steps. VIEW NOW CONTINUE WITH SETUP Position the cart so the attachment holes on the arc are directly above the attachment pins on the Foot-End crossbar. Orthopedic Traction Arc
Installation Slowly raise the table and guide the two crossbar pins into the attachment holes in the arc. When the attachment pins are seated into the attachment holes, secure the arc with a T-pin. Orthopedic Traction Arc
Installation Using the T-handle of the “Centering Pin”, tighten the bullet-nosed centering pin into the receiving hole in the Foot-End crossbar until securely held and allow the T-handle to drop below the level of the Foot-End cover. Orthopedic Traction Arc
Installation Raise the table until the arc is raised above the cart. Remove the cart. Orthopedic Traction Arc
Installation