Base Preparation
and Spinal Top Installation Base Preparation
and Spinal Top Installation Base Preparation and Connecting Hand Pendant Plug the power cord of the MTS Advanced Control Base into a properly grounded receptacle. Connect the Hand Pendant to the port on the Head-End column. Standard Component Installation and Adjustment Prior to procedure set up, refer to the Standard Component Installation and Adjustment section and complete the required steps. VIEW NOW CONTINUE WITH SETUP Power Status and Table Level Indicators Toggle the power switch to the ON position. The On/Off Power Switch, the Power Light, and the Battery Status Light should be illuminated green, and the Fault Light should be dark. Base Preparation
and Spinal Top Installation Confirm the Rotation Safety Lock, 180 Degree Rotation Lock, and Tilt Drive Status indicator lights are all illuminated blue. Movement of Slide Assembly The Head-End Column has a Slide Assembly that adjusts to accommodate Trendelenburg and reverse Trendelenburg. Fully expand the Slide Assembly to allow adequate space for a table top to be installed. Base Preparation
and Spinal Top Installation Attaching H-Frame to the Crossbar Remove the H-Frame from the H-Frame Storage Bracket located on the Head-End Column, and remove a T-Pin from the Quiver. Install the H-Frame to the Head-End Crossbar by aligning the holes on the bottom of the H-Frame with the posts on the Crossbar, and secure it in place with a T-Pin. Base Preparation
and Spinal Top Installation Install the second H-Frame to the Foot-End Crossbar and secure it in place with a T-Pin. Inserting T-Pin to Secure H-Frame to Crossbar Pass the T-Pin completely through the Crossbar such that the Drop Lock is visible and pivots freely on the opposite side. When the T-Pin is installed properly with the Drop Lock visible and pivoting freely, the T-Pin cannot be accidently removed when pulled. Base Preparation
and Spinal Top Installation Attaching the Table Top to the H-Frame to the Foot-End With the assistance of two people, lift the table top into place, aligning it with the selected mounting holes in each H-Frame. Secure the table top to the Foot-End H-Frame first with the use of a T-Pin. Pass the T-Pin completely through the H-Frame and the coupling device such that the Drop Lock is visible on the outside of the H-Frame and pivots freely. Base Preparation
and Spinal Top Installation Attaching the Table Top to the H-Frame to the Head-End To secure the table top to the Head-End H-Frame, confirm that the H-Frame and the Slide Assembly is pulled away from the Foot-End as appropriate to accommodate the length of the table top. Pass the T-Pin completely through the H-Frame and the coupling device such that the Drop Lock is visible on the outside of the H-Frame and pivots freely. Base Preparation
and Spinal Top Installation Base Preparation
and Spinal Top Installation T-Pins extended through the Crossbars and table top supporting the patient should never be removed with the patient on the table top. Removing these T-Pins may result in harm to the patient, healthcare workers or the device. Base Preparation and Spinal Top Installation Complete The Spinal Top is now properly installed on the MTS Advanced Control Base, and the patient prone components can be installed. For more information or questions about this setup, please refer to the Owner's Manual or contact Mizuho OSI for additional support. Base Preparation
and Spinal Top Installation